BRP Ski-Doo 1200 4-TEC 2018, Operator'S Manual

Page: 126 / 211

MAINTENANCE PROCEDURES
– Oil filter cover with O-ring
– Oil filter.
mmr2009-111-006_a
1. Oil filter cover screws
2. Oil filter cover
3. O-ring
4. Oil filter
5. Dispose filter as per your local envi-
ronmental regulations.
Oil Filter Installation
1. Check the oil filter inlet and outlet
orifices inside oil filter receptacle
(integrated part of magneto cover)
for dirt and contaminations.
mmr2009-111-007_a
1. Oil inlet orifice from the oil pressure pump
2. Oil outlet orifice to the engine lubrication
system
3. Oil filter receptacle
2. Install a NEW O-ring on oil filter
cover.
3. Lubricate filter seal and cover O-ring
with engine oil.
mmr2009-111-008_a
1. Lubricate with engine oil
4. Install the oil filter cover.
5. Tighten oil filter cover screws to
specification.
TIGHTENING TORQUE
Oil Filter Cover
screws
10 N•m ± 1 N•m
(89 lbf• in ± 9 lbf• in )
6. Install muffler.
Exhaust System
Exhaust System Verification
The muffler tail pipe should be cen-
tered with the exit hole in the bottom
pan. Exhaust system must be free of
rust or leaks. Make sure that all parts
are securely in place.
Check retaining springs condition and
replace if necessary.
The exhaust system is designed to re-
duce noise and to improve the total
performance of the engine. Modifica-
tion may be in violation of local laws.
NOTICE
If any exhaust system
component is removed, modified
or damaged, severe engine damage
may result.
Spark Plugs
Spark plugs inspection or replacement
may be performed by an authorized
Ski-Doo dealer, repair shop, or person
of your own choosing. Spark plugs in-
spection or replacement requires an
in-depth technical knowledge. Though
124
______________