BRP Ski-Doo 1200 4-TEC 2018, Operator'S Manual

Page: 132 / 211

MAINTENANCE PROCEDURES
2. Remove drive belt guard.
3. Loosen the clamping bolt.
mmo2011-003-010_a
1. Adjuster hub
2. Clamping bolt
4. Using the suspension adjustment
tool provided in the tool kit, turn
the ring 1/4 turn at a time then ro-
tate the driven pulley to properly set
the drive belt between the pulley
sheaves.
mmo2011-003-011_a
1. Suspension adjustment tool
NOTE: The adjustment ring has left
hand treads.
Repeat step 4 until the lowest portion
of the cogs on the external surface of
drive belt is even with the driven pulley
edge.
mmo2012-006-905_a
TYPICAL - PRELIMINARY SETTING
1. Lowest portion of cogs even with external
surface of drive belt
NOTE: Turning the ring counterclock-
wise lowers the drive belt in the pulley.
Turning the ring clockwise raises the
drive belt in the pulley.
5. Firmly tighten the clamping bolt. If
possible, tighten to specification us-
ing a torque wrench.
TIGHTENING TORQUE
Clamping bolt
5.5 N•m ± 0.5 N•m
(49 lbf• in ± 4 lbf• in )
mmo2012-004-903_a
TYPICAL
1. Clamping bolt
6. Install drive belt guard.
7. Install side panel.
NOTE: These settings are correct as a
preliminary adjustment for most mod-
els. In some cases, when starting the
engine, the vehicle could creep, indi-
cating that the drive belt is too tight.
130
______________