BRP Ski-Doo 1200 4-TEC 2018, Operator'S Manual

Page: 138 / 211

MAINTENANCE PROCEDURES
4. To correct track alignment:
4.1 Stop engine.
4.2 Remove tether cord cap from
engine cut-off switch.
WARNING
Remove tether cord cap from
engine cut-off switch before
performing any maintenance
or adjustment, unless other-
wise specified. Vehicle must
be parked in a safe place,
away from the trail.
4.3 Loosen rear wheel retaining
screws.
4.4 Tighten adjustment screw on
side where the slider shoe is
the farthest from the track in-
sert guides.
A01F0BA
1
2
3
1
1. Guides
2. Slider shoes
3. Tighten on this side
5. Tighten retaining screws.
WARNING
Properly tighten wheel retaining
bolt, otherwise wheel may come
off and cause track to “lock”.
mmo2013-004-032_a
rMOTION
1. Retighten to 48 N•m ± 6 N•m
(35 lbf•ft ± 4 lbf•ft)
6. Restart engine and rotate track
slowly to recheck alignment.
7. Reposition snowmobile on the
ground.
8. Install rear wheel caps if so
equipped.
Suspension
Rear Suspension Condition
Visually inspect all suspension compo-
nents including slider shoes, springs,
wheels, etc.
NOTE: During normal driving, snow
will act as a lubricant and coolant for
the slider shoes. Extensive riding on
ice or sanded snow, will create exces-
sive heat build-up and cause prema-
ture slider shoe wear.
Suspension Stopper Strap
Condition
Inspect stopper straps for wear and
cracks, bolt and nut for tightness. If
loose inspect holes for deformation.
Replace as required. Tighten nut to
specification.
TIGHTENING TORQUE
Stopper strap
nut
10 N•m ± 1 N•m
(89 lbf• in ± 9 lbf• in )
136
______________