BRP Ski-Doo 1200 4-TEC 2018, Operator'S Manual

Page: 127 / 211

MAINTENANCE PROCEDURES
not required, it is recommended that
an authorized Ski-Doo dealer performs
spark plugs inspection or replacement.
Engine Stopper (E-TEC)
Engine Stopper Adjustment
The engine stopper is located on the
LH front engine support, in front of the
drive pulley.
1. Remove D.E.S.S. key from post.
2. Remove the LH side panel, refer to
CONTROLS, INSTRUMENTS AND
EQUIPMENT
.
3. Remove drive belt guard, refer to
DRIVE BELT GUARD REMOVAL
subsection in
CONTROLS, INSTRU-
MENTS AND EQUIPMENT
.
4. Loosen the three screws retaining
the engine stopper to the engine
support just enough to allow a verti-
cal play (1/2 to one turn).
mmo2010-009-007_a
1. Drive pulley
2. Engine stopper screws
3. Engine stopper
5. Insert a 0.5 mm (.02 in) feeler gauge
in the engine stopper opening (see
illustration).
mmo2010-009-001_a
1. Opening
2. Feeler gauge
6. Place feeler gauge between engine
stopper and rubber stop block (on
engine).
NOTE: Do not insert the feeler gauge
too deep, as it will pass over the bump
at the surface of the rubber stop block
and alter adjustment. See illustration.
mmo2010-009-002_a
1. Rubber stop block
2. Bump
3. Feeler gauge
7. Tighten screws to 10 N•m ± 2 N•m
(89 lbf• in ± 18 lbf• in ) following the
illustrated sequence, taking care not
to pinch the feeler gauge.
______________
125