BRP Ski-Doo 1200 4-TEC 2018, Operator'S Manual

Page: 123 / 211

MAINTENANCE PROCEDURES
NOTICE
Operating the engine
with an improper oil level may se-
verely damage engine. Wipe off any
spillage.
Make sure the engine is at normal oper-
ating temperature.
NOTE:
The engine reaches its normal
operating temperature when the rear
radiator gets warm.
Place vehicle on a level surface and
proceed as follows to check oil level:
1. Let engine run at idle for approxi-
mately 30 seconds.
2. Stop engine.
3. Remove the drive belt guard, re-
fer to
CONTROLS, INSTRUMENTS
AND EQUIPMENT
.
4. Remove dipstick from the filler tube,
then wipe it clean.
5. Completely insert dipstick in the
filler tube.
6. Remove dipstick and check the oil
level. Oil level should be between
the MIN and MAX marks as shown,
add if necessary.
1
MAX.
MIN.
mmo2009-005-027_a
1. Oil level between MIN. and MAX.
WARNING
Wipe off any oil spills. Oil is highly
flammable when heated.
Engine Oil Replacement
WARNING
The engine oil can be very hot.
Wait until engine oil is warm.
NOTICE
Engine oil and oil filter
must be replaced at the same time.
1. Place vehicle on a level surface.
2. Remove the LH side panel.
3. Remove the drive belt guard. Re-
fer to
CONTROLS, INSTRUMENTS
AND EQUIPMENT
section.
4. Remove dipstick.
mmr2009-111-100_b
LH SIDE OF VEHICLE
1. Oil tank dipstick
5. From underneath the vehicle, ac-
cess the drain plug:
5.1 Remove one access cover re-
taining screw and loosen the
other.
5.2 Pivot the access cover to clear
the bottom pan opening.
______________
121