10/132 Safety instructions
Bosch Rexroth AG
, SYEPS series 1X, RE 30201-B/07.2014
2 Safety instructions
2.1 About this chapter
The product has been manufactured according to the generally accepted rules of
current technology. There is, however, still a risk of personal injury or damage to
equipment if you do not observe this Chapter and the safety instructions contained
in this documentation.
▶
Read these instructions completely and thoroughly before working with the
product.
▶
Keep this documentation in a location where it is accessible to all users at all
times.
▶
Always pass the product together with the required documentation to third
parties.
2.2 Intended use
The SYEPS punching system is an electrohydraulic system component.
You may use the product as follows:
•
for controlling the punching strokes of NC punching machines in different
operating modes.
The product is intended exclusively for professional use and not for private usage.
Operation according to the intended use also implies that you have read and
understood this documentation completely, especially Chapter 2 “Safety
instructions“.
2.3 Improper use
Any use other than described in the section “Intended use” is considered as
improper and is therefore not permitted.
For damage resulting from improper use, Bosch Rexroth AG will not bear liability.
The risks arising from improper use lie exclusively with the user.
If unsuitable products are installed or used in safety-relevant applications,
unintended operational states may occur in the application that can cause
personal injury and/or damage to property. For this reason, use a product only in
safety-relevant applications, if this use is expressly specified and permitted in the
documentation of the product. For example, in explosion-protection areas or in
safety-related parts of a control (functional safety).
The product is used improperly:
•
If you do not adhere to the technical data, operating conditions and performance
limits specified in the data sheet and given in the order confirmation
•
If you do not observe national EMC regulations during operation for the application
at hand. Notes on an EMC-compliant installation can be found in the EMC test
documentation of Bosch Rexroth, if required. The manufacturer of the system or
machine is responsible for complying with the limit values stipulated in national
regulations (European countries: EC Directive 2004/108/EC (EMC Directive); USA:
See National Electrical Code (NEC), National Electrical Manufacturers Association
(NEMA) as well as regional engineering regulations.
