BMS APU08E, Owner'S Manual

Page: 118 / 158

118
Drain the system completely and reinstall
the coolant drain plug.
Pinch hose between radiator and
thermostat housing with a large pincher or
an equivalent.
CAUTION: Do not use vise-grip pliers to
pinch hose.
Fill the radiator until the coolant comes out
by the thermostat housing hole.
Complete the radiator filling.
Check the level in the coolant reservoir
and refill if necessary.
Run engine at idle with the radiator cap off.
Slowly add coolant if necessary.
As this point, wait until engine reaches
normal operating temperature. Depress the
throttle level two or three times; then add
coolant if required.
Install radiator cap. Inspect all connections
for leaks and check coolant level in the
reservoir.
Air Filter
Removal
CAUTION: never remove or modify any
component in the air filter housing.
Otherwise, engine performance
degradation or damage can occur. The