Black Box ServSelect KV119A, Installer/User Manual

Page: 52 / 84

CHAPTER 6: SCPS COMMANDS
51
Parameter Description
STOP=< stop_bits > Number of stop bits per character. Valid values are 1 and 2.
Default = 1
FLOW=< fl ow_ctrl > Flow control. For hardware fl ow control, be sure the control
signals are correctly wired, or data loss may occur. Valid
values are:
XONXOF
Specifi es software XON/XOFF fl ow control
RTSCTS Specifi es hardware RTS/CTS fl ow control
DTRDCD Specifi es hardware DTR/DCD fl ow control
Default = XONXOF
TIMEOUT=< time-out > Number of time-out minutes in the range Ø-90. If no data
is received or transmitted during a Telnet session for the
specifi ed period, the session will time-out. A zero value
indicates no time-out. This value overrides the time-out
value set with a Server CLI command.
Default = 15 minutes
SOCKET=< socket > Socket number that is specifi ed on the Telnet client to connect
to this serial port. The new value becomes effective after the
next SCPS reboot.
When SSH is enabled, the SCPS automatically adds 100
to the specifi ed value.
When All is specifi ed, port 1 will be assigned the specifi ed
socket value plus 1, port 2 will be assigned the specifi ed
value plus 2, and so on. When All is specifi ed and SSH is
enabled, port 1 will be assigned the specifi ed socket value
plus 101, port 2 will be assigned the specifi ed value plus
102, and so on.
Default = 3000 plus the port number, 3100 plus the port
number if SSH is enabled; see above for action taken if All
is specifi ed
CHAR=^< cli_char > CLI access character in the range A to - (dash) or None.
The CLI access character, when pressed simultaneously
with the
Ctrl
key during a session with an attached serial
device, will suspend the session with the device and
place you in CLI command mode. If None is specifi ed, the
value specifi ed in the Char parameter of the Server CLI
command will be used.
Default = ^d
TOGGLE=NONE|DTR When set to DTR, the SCPS will toggle the port’s DTR-out
signal off for 1/2 second each time a connection is made to
the port.
Example
The following command sets a baud rate of 57600 and enables XON/XOFF flow
control on port 2.
> port 2 set baud=57600 flow=xonxof