Black Box ServSelect KV119A, Installer/User Manual

Page: 62 / 84

CHAPTER 6: SCPS COMMANDS
61
Server SNMP Manager Command Parameters
Parameter Description
ADD|DELETE Adds or deletes the specifi ed SNMP management entity.
< ip_address > IP address of SNMP management entity.
Example
The following command adds an SNMP management entity with the IP address
of 192.168.0.1.
server snmp manager add 192.168.0.1
Server SNMP Trap command
The Server SNMP Trap command enables or disables SNMP traps. When you issue this
command with the Enable parameter, the SCPS displays a numbered list of all currently
disabled traps. When you issue this command with the Disable parameter, the SCPS
displays a numbered list of all currently enabled traps.
You may indicate the traps to be enabled/disabled by entering a single number,
several numbers separated by commas, a range of numbers separated by a dash or a
combinations of numbers separated by commas and dashes. You may also type ALL
to select all traps in the list or press Enter , which cancels the operation.
If you specify ALL on the command line, the numbered list is not displayed.
If you enable a trap but there is no trap destination configured for it, a warning will
be issued. In this case, issue a Server SNMP Trap Destination command.
NOTE:
By default, all traps are disabled. The PortAlert trap must be enabled for port alert processing to
be performed.
For more information, see
Managing SNMP Structures
in Chapter 4. The supported
traps are listed in Chapter 7.
Access: SCON
Syntax
SERVER SNMP TRAP [ENABLE|DISABLE] [ALL]