Black Box ServSelect KV119A, Installer/User Manual

Page: 16 / 84

CHAPTER 3: INSTALLATION AND CONFIGURATION
15
Parity None
Stop bits
1
Flow control None
3. Press the Return or Enter key until a prompt appears, requesting your
username. If you do not receive a > prompt after pressing the key fi ve times,
check your cable and serial settings to be sure that they are correct.
4. Proceed to Initial SCPS login in this chapter.
After you complete the SCPS configuration, you may reconfigure the CLI on
another port or disable it completely and use port 1 with an attached device. For
more information, see Connecting to devices from the serial CLI port in Chapter 4.
Initial SCPS login
The SCPS ships with a single user defined in its user database. The first time you
connect to the SCPS via Telnet or serial CLI, you are prompted for a username.
To log in to the SCPS for the fi rst time:
1. At the Username prompt, type Admin . There is no password for the Admin
user. At the password prompt, press Return .
2. Once authentication completes, the SCPS prompts for any missing
confi guration values that are required for operation.
If you already provided the IP address and subnet mask, you will not be
prompted for those values again.
If you have not already provided the IP address and subnet mask, you will be
prompted for them. Enter the SCPS IP address and subnet mask using standard
dot notation.
3. You are prompted for a new Admin password. Passwords are case sensitive and
must contain 3-16 alphanumeric characters. You must enter the new password
twice to confi rm that you entered it correctly.
After you have provided the required configuration information, the following
message appears while the SCPS stores the values in its configuration database.
Configuration is being stored. Please wait.
IP Address is 192.168.0.5 with subnet mask 255.255.255.0 has
been set
New Admin password has been set
>
You have now completed the initial login, and you may enter additional commands
at the CLI prompt (>). To configure other SCPS ports, see Configuring Serial Port
Settings in Chapter 4.