Black Box ServSelect KV119A, Installer/User Manual

Page: 12 / 84

CHAPTER 3: INSTALLATION AND CONFIGURATION
11
3. Installation and Configuration
3.1 Hardware Overview
Figure 3-1 shows the front panel of an SCPS.
Figure 3-1. SCPS Front Panel
The lower left area of the front panel contains five LEDs and two buttons, which are
described in the following table.
SCPS LEDs
LED/Button Description
POWER The POWER LED illuminates when the SCPS is
connected to a power source.
ONLINE The ONLINE LED illuminates steadily (not blinking) when
the SCPS self-test and initialization procedures
complete successfully.
LINK The LINK LED illuminates when the SCPS establishes a
connection to the network.
TRAFFIC The TRAFFIC LED blinks when there is network traffi c.
100MBps The 100MBps LED illuminates when the SCPS is
connected to a 100 MBps LAN.
RESET The RESET button, when pressed, reboots the SCPS.
INIT The INIT button, when pressed, restores the SCPS to
factory defaults; for more information, see
Reinitializing the
SCPS in this chapter.
As shown in Figure 3-2, the back of the SCPS contains 8 (SCPS-8) or 16 (SCPS-16)
RJ-45 connectors for serial cabling, a LAN connector for a 10BaseT or 100BaseT
interface cable and a power receptacle.
Figure 3-2. SCPS-16 Back Panel