Black Box ServSelect KV119A, Installer/User Manual

Page: 15 / 84

SERVSELECT™ IP SCPS INSTALLER/USER GUIDE
14
In this case, check the MAC address and IP address provided to the BootP
server to confi rm they are correct. Verify that the Ethernet LAN adaptor cable
is correctly installed on the SCPS and the Ethernet hub.
After the IP address is configured successfully, launch a Telnet session to the SCPS
IP address. Then, see Initial SCPS login in this chapter.
To con fi gure the IP address and subnet mask using a Telnet CLI:
1. Ensure that your server or workstation has a Telnet client and is located on the
same LAN segment as the SCPS.
2. Use the arp command to update the server or workstation with the SCPS IP
address and Ethernet MAC address. The SCPS Ethernet MAC address is
located on the back panel above the LAN connector. The arp command is
entered as:
arp -s <ip_address> <mac_address>
For example, the following command assigns the IP address 192.168.0.5 and
the Ethernet MAC address 00-80-7d-54-01-54 to the SCPS.
arp -s 192.168.0.5 00-80-7d-54-01-54
On a UNIX platform, the MAC address may require colons (:) instead of
dashes (-), for example, 00:80:7d:54:01:54.
3. You may verify that you entered the information correctly by using an arp
command with the -a option.
arp -a
This command shows all arp entries for the server or workstation. See your
system administrator guide if you need additional help with the arp command.
4. After the above arp command is entered correctly, launch a Telnet client to the
assigned IP address. Then, continue with
Initial SCPS login in this chapter.
To con fi gure the SCPS using the serial CLI:
1. By factory default, port 1 of the SCPS is confi gured for the serial CLI. To
access the serial CLI, attach a compatible device to port 1. The compatible
device types are: ASCII, VT52, VT100, VT102, VT220, VT320, IBM3151,
IBM5250 and WYSE50.
Chapter 8 lists the required cables and adaptors. You may also use any terminal
emulation program that is available on your system.
2. Confi gure your terminal or terminal emulation program as follows.
Baud rate 9600
Bits per character 8