BIOTRONIK Lumax DR ICD Series, Technical Manual, Page: 119 / 176

Lumax Technical Manual 111
•
Impedance out-of-range for A, RV, LV, shock lead
(painless)
•
Special Device Status
•
First ineffective 30 J shock detected
•
Initial detection SVT
•
Percent of ventricular sensing below set limit
•
Device status – ERI/EOS/ROM-Mode
Programmer Triggered Report
With the device status screen, it is possible to test the
ICD/CRT-D’s Home Monitoring capabilities during device
implantation or follow-up.
N
OTE
:
Battery voltage and pace/sense lead impedance are
measured before the first transmission of the day. Therefore,
the first transmission may occur 2 minutes after the
programmed transmission time.
W
ARNING
A timely receipt of the event report cannot be guaranteed.
The receipt is also dependent on whether the patient was
physically situated in the required coverage range of the
patient device at the time the event information was sent.
2.11.2.5 Description of Transmitted Data
The following data are transmitted for the Cardio Report by the
Home Monitoring system, when activated. In addition to the
medical data, the serial number of the implant is also transmitted.
Device Status & Home Monitoring Settings
Containing device and message identifying values that pertain to
the implant and Home Monitoring:
•
Implantation Date
•
Battery voltage & Date of Measurement