Bionet BM Elite Series, Instructions For Use Manual

Page: 130 / 215

Rev. 5.01
130
been on. (LoFlo only)
A-4-8. Pump max time
This value indicates the maximum
rated lifetime of the sampling pump.
(LoFlo only)
Min. display
A-5. Module setup Module setup menu
A-5-1. Current period
This setting is used to set the
calculation period of the ETCO2 value.
The end-tidal CO2 value is the highest
peak CO2 value of all end of
expirations (end of breaths) over the
selected time period. If less than two
breaths exist in the selected time
period, the value will be the maximum
ETCO2 value for the last two breaths.
1 breath,
10 sec,
20 sec
A-5-2. Balance gas
setup the gas in the measurement;
the type of gas that is mixed with the
breathing gas measuring Room air
N2O
Helium
A-5-3. Sleep mode
Sleep mode is used to save power
when the host monitor is in standby
mode. There are two sleep modes
available for the Capnostat. Using
Sleep Mode 1 maintains the heaters so
the Capnostat is able to run
immediately after exiting the sleep
mode. Mode 2 will require the
Capnostat to go through its warmup
sequence when exiting this mode and
a delay will be introduced until the
system has stabilized.
Normal mode
Turnoff mode
Power saving
A-5-4. BARO. pressure
This setting is used to set current
Barometric Pressure.
760mmHg
A-5-5. Gas temperature
This setting is used to set temperature
of the gas mixture. This setting is
useful when bench testing using static
35.0 ° C