Bionet BM Elite Series, Instructions For Use Manual

Page: 55 / 215

Rev. 5.01
55
If you do not have firewall and antivirus software:
⚫
Your data is not protected.
⚫
The device settings could be changed
⚫
The device raises an error alarm or does not generate an alarm.
⚫
Data is sent incomplete, to the wrong device, or not at all.
⚫
Animal patient data is blocked, falsified, or corrupted.
⚫
The time stamp of the data is inaccurate
Overloading this unit due to very high network loading (e.g. denial of service attacks) can cause
interface deactivation. The interface can only be used again after the device is restarted. Rarely,
booting may be slow or repeated reboots may occur
Bed-to-Bed Viewing
If the monitor is connected to a network, you can view other monitors connected to the network
on your monitor and make the alarm silent. The procedure for displaying the remote view screen
is as follows. To set the menu display time, refer to the setting page below.
Note
The Print Screen Sticky key on the front panel of the monitor allows you to
print the remote view screen as it appears on your local monitor.
The menu below is a setup menu for retrieving data from other veterinary multiparameter
monitoring devices connected to the same network. To view the menu settings, touch the My BED
number box in the top menu bar.