6.2.5
Additional bleed resistor
The additional bleed resistor FZP 200 (180 ohms, 150 W) can be used
for dissipating a larger amount of braking energy (fig. 6-8).
DANGER
High voltages are present at the bleed resistor connections (approx.
325 VDC).
DANGER
The bleed resistor heats up when a great amount of braking energy
is produced.
ATTENTION
Good heat dissipation must be ensured when installing the bleed
resistor.
1.
Switch the mains voltage OFF.
2.
Provide the two bleed resistor leads with wire end ferrules on the
device end.
3.
Connect the two litz wires to the terminals at the bottom of the unit.
B+
WDP3-01X
B-
18
22
0
10
0
90
4.5
65
Fig. 6-8 Additional bleed resistor
Appendix
WDP3-01X Ident. no.: 00441109760
6-11
(only at units < RS40)
