Bender ATICS-2-63A-DIO, Manual

Page: 73 / 104

Menu mode: Operation and setting
73 ATICS-DIO_D00080_01_M_XXEN/04.2015
7.3.4.5 Settings menu 5: Digital Input
On this menu, you can adjust settings for the mode of operation and function of the digital inputs.
The digital inputs are galvanically isolated. They are designed for an input signal of AC/DC 24 V.
For each input, selection is possible when the input is set to: "24V" (high) or "0V" (low). In the "24V"
setting, the selected function (e.g. alarm message) is carried out when there are 24 volts there. In the
"0V" setting, the selected function is carried out when there are 0 volts there. It is for this reason that
you should always set unused digital inputs to "off".
Select the digital input:
1. Use the arrow button "

" to set the digital input. Press "
↵
".
2. Use the arrow buttons to select a digital input (e. g. Dig. Input 3) or all four digital inputs (Dig.
Input 1…4). Press "
↵
" to confirm your selection.
Adjusting the settings:
If the digital input function is selected, then the recommended response value is
automatically adjusted:
- Test, H/A
24V (cannot be changed)
- no2->1, 1<->2, bypass, alarm and R-OPL 0 V (can be changed)
Menu Meaning
Exit Leave the settings menu "Digital menu; go up one menu level
Dig. Input: 3
Exit
1.Mode: off
2.Resp.val.: 24.0V
Dig. Input: 1..4
Exit
1.Mode: off
2.Resp.val.: 24.0V
Setting one digital input
Setting all digital inputs