Bender ATICS-2-63A-DIO, Manual

Page: 63 / 104

Menu mode: Operation and setting
63 ATICS-DIO_D00080_01_M_XXEN/04.2015
7.3.2 Menu 2: Changeover
Displays information on the changeover function (number, test). The device shows the alarm status
for each menu item:
=
no alarm,
=
alarm
21. Phase sequence: left
Line 1: Phase sequence of the phases L1, L2, L3
22. U2(1-N): 230V
Line 2: Measured value mains voltage phase L1 to neutral conductor N
23. U2(2-N): 230V
Line 2: Measured value mains voltage phase L2 to neutral conductor N
24. U2(3-N): 230V
Line 2: Measured value mains voltage phase L3 to neutral conductor N
25. U2(1-2): 400V
Line 2: Measured value mains voltage phase L1 to phase L2
26. U2(2-3): 400V
Line 2: Measured value mains voltage phase L2 to phase L3
27. U2(3-1): 400V
Line 2: Measured value mains voltage phase L3 to phase L1
28. Line 2: 50.0Hz
Line 2: Measured value frequency
29. Asymmetry: 0%
Line 2: Asymmetry of the phases L1, L2, L3
30. Phase sequence: left
Line 2: Phase sequence of the phases L1, L2, L3
All messages (with the exception of measured value "frequency") are also avail-
able on the BMS bus (also refer to "Messages with error code or service code" on
page 82).
Menu Meaning
Exit Exit "Changeover" menu; go up one menu level
1. Changeover: xxx
Number of changeovers performed
2. Operat. time: xxh
Operating hours counter (h=hours, d=days, mo=months)
3. Changeover I>: xx
Number of changeovers performed which were carried out with overcurrent
of short-circuit current. These changeovers reduce the life of the ATICS®
transfer switching device.
Currents in excess of 150 A resp. 260 A (if an STW4 is used) are considered to
be overcurrent or short-circuit currents.
4. TEST: dd.mm.yy
Date for next test (changeover)
5. Service: dd.mm.yy
Date for next service
6. Test: dd.mm.yy
Date of the last test (TEST) or the last changeover (LAST SWITCH)
Menu Meaning