Bender ATICS-2-63A-DIO, Manual

Page: 69 / 104

Menu mode: Operation and setting
69 ATICS-DIO_D00080_01_M_XXEN/04.2015
7.3.4.2 Settings menu 2: Voltage
On this menu, you can adjust settings for monitoring the voltage on Line 1 and Line 2 individually or
together.
Example: Line 1 is set to "Undervolt: 184 V". If the voltage on Line 1 falls below 184 V, the device
displays an alarm message. If the voltage on Line 2 is within the set range, a change-
over to Line 2 follows. The ATICS® returns to Line 1 if the voltage on Line 1 exceeds
the pre-set value (in this case: 184 V) plus the selected hysteresis.
Selecting a line:
1. Use the "

" arrow button to go to the line setting. Press "
↵
".
2. Use the arrow buttons to select one line (Voltage 1, 2) or both lines (Voltage 1…2). Press "
↵
" to
confirm your selection.
Adjusting the settings:
* Also note the time charts on Page 17ff.
Menu Meaning
Exit Exit settings menu "Voltage"; go up one menu level
1. Undervolt. Setting range: 160…207 V
2. Overvoltage Setting range: 240…275 V
3. t(on) Response delay*:
Setting range:
50 ms…100 s
Resolution of settings: 50 ms/100 ms/1 s/5 s/10 s
4. t(off ) Delay on release*:
Setting range:
200 ms…100 s
Resolution of settings: 50 ms/100 ms/1 s/5 s/10 s
5. Hysteresis Setting range: 2…10 %
Resolution of setting: 1 %
6. Asymmetry
(ATICS-4-DIO only) Setting range: 2…30 %
Resolution of setting: 1 %
7. Phase sequence
(ATICS-4-DIO only) on: Phase sequence monitoring switched on
off: Phase sequence monitoring switched off
Voltage: 2
Exit
1.Undervolt.: 184V
2.Overvoltage: 250V
Voltage: 1..2
Exit
1.Undervolt.: 184V
2.Overvoltage: 250V
Setting
a voltage for one line
Setting a voltage for both
lines