Bender ATICS-2-63A-DIO, Manual

Page: 65 / 104

Menu mode: Operation and setting
65 ATICS-DIO_D00080_01_M_XXEN/04.2015
7.3.3.1 Operating example: History
1. Use the arrow buttons to select the entry you require. The most recent entry appears first on
the display. Older messages can be selected using the arrow buttons.
2. Press "
↵
" to call up the message text for the selected entry. The path the message took to
reach the device is displayed (In this case: Undervoltage, BMS bus address 3, channel 1). The
table on the following page contains information about other possible displays.
3. Press "
↵
" again to go back to the entry selection screen.
Repeat this process for all required messages. Then press "ESC" to exit the menu.
Displays "TEST" in the last line of the history memory message display: Note that the current history
memory entry was created as the result of a test initiated on this device.
7.3.3.2 Operating example: Config.logger
1. Use the arrow buttons to select the entry you require. In this case: The settings for the digital
input are changed here.
2. Press "
↵
" to call up the additional text for the selected entry. The function of the digital input
has been changed from "off" to "0". The last line contains an identification code for the type of
modification (in this case: [4/1]). Channel 1 means that the first digital input has been changed.
Please contact the Bender Service and provide the identification number, when the modifica-
tion led to an undesirable behaviour of the device.
History 500/500
Start:
04.12.08/
16:00:01
Quit:
04.12.08/16:00:33
History 500/500
Undervoltage
min.
0V
/
max.
0V
Addr.:3 Channel:1
CONFIG. LOGGER 10/17
Modific.(auto)
Digital Input
04.10.11/16:03:17
CONFIG. LOGGER 10/17
Mode
off -> 0
Channel.: 1 [4/1]