Bender ATICS-2-63A-DIO, Manual

Page: 55 / 104

Operation
55 ATICS-DIO_D00080_01_M_XXEN/04.2015
6.2.5 Reset function
A reset is used to reset the alarm and fault messages for the device and for releasing the switching-
back interlocking function of the changeover switch. There are several ways to call up a test menu:

Select standard display and then press the "RESET" button on the front panel of the device for
at least one second.

Call the "RESET" function in the Control menu. Reset menu:
Select:
6.2.5.1 Reset menu 1: Alarm
Delete Resets alarm and fault messages on the device. The progress of the test is
shown on the display.
The reset is required if one or more alarm-triggering parameters are not con-
stantly monitored so that the end of the alarm condition was not detected.
Cancel Back to reset menu
For all pending alarms, the date and time of the reset are entered in the line "to" in the history mem-
ory. The "ALARM" LED goes out.
If the fault persists, a new entry is written in the history memory. The "ALARM" LED is still lit up.
Menu item Function Page
1. Alarm Resets alarm and fault messages on the device. 55
2. SwitchBackLock. Reactivates the switching-back interlocking function for the change-
over function. The device changes back to the redundant line. 56
3. Changeover Change alarm value for the:
- maximum number of changeover operations performed
- maximum number of operating hours
- maximum number of changeover operations performed
which were carried out with overcurrent or short-circuit current 57
Exit
1.Alarm
2.SwitchBackLock.
3.Changeover
Delete
Cancel
Delete