Bender ATICS-2-63A-DIO, Manual

Page: 81 / 104

81 ATICS-DIO_D00080_01_M_XXEN/04.2015
8. Troubleshooting
8.1 Fault and alarm messages
In the event of an alarm, the messages of the ATICS® will enable you to narrow down the possible
causes. Some messages may point to several causes. The following possible faults are indicated by
messages on the ATICS® display:

Plain text fault messages

Fault messages with error code
8.1.1 Plain text fault messages
Fault/message Description Remedy
Failure Line xx
(xx stands for: 1, 2,
AV, SV, UPS, BSV),
undervoltage or
overvoltage Voltage is no longer available on
Line 1 or Line 2
(Channel 1 = Line 1,
Channel 2 = Line 2) - Measure voltage on Line xx.
- Check cause.
- Eliminate fault on the system.
- Check the setting for voltage and hystere-
sis.
Failure Line 2 Generator delivers no voltage
within the set time
Device error +
Errorcode For details about actions to be taken refer to table section "Error code/service
code". The message is on channel 6 of the BMS bus.
Short-circuit
distribution board Short-circuit detected - Eliminate short-circuit
Failure distribution
board No voltage on Line 3, contact of
the changeover switch defective - Replace the ATICS®.
Overcurrent I(3) Measuring current transformer T3
resp. one of the measuring current
transformers T3…T6 recognised
an overcurrent - Eliminate the cause of overcurrent.
- Eliminate any damage.
CT connection
CT short-circuit Measuring current transformer T3
resp. T3…T6, channel 7 - Check connecting wire of the measuring
current transformer(s).
No MASTER There is no device with master
function or back-up master (device
with address "1") available on the
RS-485 interface - Check BMS bus connection cable.
- Check whether master has failed or wheth-
er its address has changed
Service: __ (date) Reminder for next service - Agree date with Bender Service
Test:
__ (date) Reminder for next test - Plan date for test.
- Carry out test.
Manual mode Message "Manual mode" although
manual mode has not been
activated - Check the connections of the digital input