Bender ATICS-2-63A-DIO, Manual

Page: 90 / 104

Periodic verification and service
90 ATICS-DIO_D00080_01_M_XXEN/04.2015
9.6.1 Removing the existing ATICS®
1. Record settings on the existing ATICS®.
The settings should match the entries on the checklist (see checklist in the appendix of this
manual or, if necessary, update checklist).
2. Make device dead or switch on the bypass switch. Switch existing ATICS® to manual mode and
switch to switch position "0" see "Connecting the ATICS® safely" on page 28).
3. Remove connections
4. Remove the ATICS®
Removing the ATICS® from rail mounting
The photo shows ATICS-2-DIO.
The description also applies to ATICS-4-DIO.
ATICS-2-DIO: Undo the mounting screws on
the upper green plug connector and remove
the connector (A).
ATICS-4-DIO: Undo the mounting screws on
the upper green plug connectors and
remove the two plug connectors.
Only then, undo the mounting screws of the
lower green plug connector and remove the
connector (B).
Remove the other three connector plugs (C).
Undo screws (D).
A B
C
D