Bender ATICS-2-63A-DIO, Manual

Page: 10 / 104

Safety instructions
10 ATICS-DIO_D00080_01_M_XXEN/04.2015
2.3 Device-specific safety instructions
2.4 General safety instructions
Bender devices are designed and built in accordance with the state of the art and accepted rules in
respect of technical safety. However, the use of such devices may introduce risks to the life and limb
of the user or third parties and/or result in damage to Bender devices or other property.

Only use Bender equipment:
– As intended
– In perfect working order
– In compliance with the accident prevention regulations and guidelines applicable at the
location of use

Eliminate all faults immediately which may endanger safety.

The device may not be opened.

Do not make any unauthorised changes and only use replacement parts and optional accesso-
ries purchased from or recommended by the manufacturer of the equipment. Failure to
observe this requirement can result in fire, electric shock and injury.

Information plates must always be clearly legible. Replace damaged or illegible plates immedi-
ately.

Make sure that the dimension of the UPS (special safety power supply source), the generator set
and the whole wiring is adequate. Abide by the relevant, applicable national and international
standards. If there is an overload and short-circuit, this is the only way to guarantee the neces-
sary safety and to ensure that the safety devices respond selectively.

If the device is overloaded by overvoltage or a short-circuit current load, it must be checked
and replaced if necessary.
2.5 Delivery conditions, guarantee, warranty and liability
The conditions of sale and delivery set out by Bender shall apply.
Conditions of sale and delivery can be obtained from Bender in printed or electronic format.
Failure to adjust the settings may result in malfunction
TDevice-specific settings are required in order to adapt the ATICS® transfer
switching device to the existing equipment. When doing so, follow the instruc-
tions in chapter "5. Commissioning, settings and testing", page 39ff.
Functional safety according to IEC 61508 can only be guaranteed when
used properly.
Please follow the instructions given in this operating manual and in the check
list.
In particular note the information on the pages: 12, 13, 14, 19, 57 and 84.
WARNING
WARNING