Thank you for purchasing EasyPro's Cabrio color changing LED light strips. With
this LED light you can illuminate a pond or waterfall, highlight a deck or patio
and extend the enjoyment of your entire landscape in the evening hours. This
light is fully submersible and may be used in or out of water.
Safety and Electrical Connections
1.
Always disconnect the electrical supply before handling, maintaining,
repairing or installing any pond equipment.
2. Light(s) must be attached to a 12 volt AC UL listed transformer.
3. Never connect the lights directly to a 110 volt or higher outlet.
4. Connect the transformer to a 110 volt receptacle that is protected by a
Ground Fault Circuit Interrupter.
5. Do not modify wiring in any way, quick plug ends must stay intact and
should not be replaced with terminals. DO NOT modify the white antenna on
the control module. Do not submerge control module.
6. All electrical work must be performed by a qualified technician. Always
follow the National Electrical Code (NEC) or the Canadian Electrical Code as
well as all local, state and provincial codes. Failure to follow manufacturer’s
installation instructions may result in electrical shock, fire hazard, personal
injury or death, damaged equipment, provide unsatisfactory performance
and will void manufacturer’s warranty.
Installation of LED Light Strip
1. Before installing the product check for damaged or missing parts. Contact
EasyPro immediately if pieces are missing or damaged.
2. Be sure the power is disconnected before installing the lights.
3. Determine desired location to place the LED strip.
Note: Be sure to consider that individual diodes cannot be replaced at the
end of their life. Permanent settings may not be the best option in the case
that the entire LED strip must be replaced.
CLED11 • CLED23 • CLED35
Cabrio Color Changing LED Light Strips
Instructions for Operation • Safety • Warranty
lighting series
by EasyPro Pond Products
