4. Place the LED strip in desired location and secure. Anchor points on both
ends of the strip may not be required for installation in some applications.
5. Run wire from LED strip back towards control module and power source.
6. Join the light to the control module by connecting
the 4-prong quick plug, tighten the retention ring to
ensure a secure connection. (Figure 1) Do not sub-
merge connection or control module.
7. Join the control module to the transformer by
connecting the 2-prong quick plug and tighten the
retention ring. (Figure 2)
Note: Power supply must be maintained to control
module or light will default back to mode 1 on start-
up (transformers with automatic operation will reset
the control module back to default on each start
due to power interruption.)
8. Plug the transformer into a GFCI outlet.
9. The LED light strip will default to mode 1 on initial startup. Use CLEDRC
remote to sync multiple Cabrio fixtures together, change modes, brightness
and speed.
Power on/off
Slower Speed
Lower Brightness
Change Mode Backwards
Red (mode 21)
Blue (mode 23)
Reset Defaults (mode 1)
Faster Speed
Raise Brightness
Change Mode Forwards
Green (mode 22)
White (mode 27)
Remote Control Operation
(remote control sold separately)
• A single remote can operate multiple Cabrio fixtures in any combination
within its range.
• Depress mode, brightness and speed buttons slowly and deliberately to
ensure all light fixtures remain in sync on the same cycle.
• Desired setting must be achieved by clicking remote functions, holding a
button down will not change settings.
• CLEDRC remote requires an A23 battery (included).
Installation of LED Light Strip (continued)
A23 battery included
Figure 1
Figure 2
