SpinLite® Full Side Washer
1MANUL961
Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681
57
Maintenance
Troubleshooting
Problem
Cause
Solution
Cleaning Hubs not
spinning
•
Mechanical failure may be
possible
•
Electrical failure
•
Check to see if bearings are seized up. If
so, see replacement parts.
•
Check motor starter
Cleaning Hubs will not
extend and/or retract
•
Faulty electrical signal
•
Connection of Extend and
Retract Airlines to Air Panel
and Arm Cylinders
•
Check electrical signal
•
Verify that the extend and retract airlines
are properly and securely connected at
the air panel and arm cylinders
Inadequate Chemical
/Water spray
•
Clogged nozzles
•
Clean nozzles by removing nozzle bodies
and tapping or inserting a thin wire into the
nozzle opening
Excessive vibration
•
Floor lags may be loose
•
Bearing may need replacing
•
Make sure that the SpinLite® Full Side
Washer is tightly lagged to the floor
•
Check for play in the pivot arm bearings,
if sloppiness is evident, bearings will
have to be replaced. See replacement
parts
LEDs not working
•
Wire connections not seated
properly
•
Pins in wire connectors may
be bent
•
Water inside electrical
connections
•
Wear on wires from hub
skins
•
Make sure all the electrical connections
between the cable, slip ring, wire harness,
and LEDs are aligned and seated
properly
•
Check to make sure that the pins in the
connectors are not bent
•
Apply dielectric grease to the electrical
receptor and reconnect the connectors
•
Wrap the connections with electrical tape
to protect them from the car wash
elements
•
Verify all wires are secured to the
driveshaft
and
there
is
adequate
clearance between the wires and hub
skins to prevent wear on the wires
