SpinLite® Full Side Washer
1MANUL961
Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681
4
Operational Warning
Formulations containing the chemicals listed below are particularly dangerous and
should not be
used
even at low concentrations:
•
Hydrofluoric Acid
•
Ammonium Bi-fluoride
•
Bromic Acid
•
Muriatic Acid
•
Sulfonic Acid
•
Phosphoric Acid
•
Hydrogen Cyanide
•
Hydrochloric Acid
•
Chlorinated Solvents
Belanger, Inc.®, does not endorse or condone the use of chemicals that are potentially dangerous to human health, the
environment, or property. Belanger® recognizes that it is the right and sole decision of the end-user operators of our
equipment as to the type and dilution ratio of the chemicals used in their facilities. We strongly recommend that the end-
user does not select products containing any of the chemicals listed above as an ingredient in the wash solutions. The
chemicals listed above are potentially dangerous to human health and have a detrimental, deteriorating effect on the
equipment and the facility. Be advised that a portion of, or all of your warranty will be voided if you determine to use any of
the chemicals listed above as an ingredient in the wash solutions in conjunction with your Belanger® automatic car wash
equipment:
Limitation (4), of Paragraph (8), Limited Warranty, of the Belanger® Terms and Conditions of Sales describes the
potential limitation of warranty due to your chemical selection:
(4) This warranty shall be void for all equipment failures and premature component wear caused by the use of corrosive
chemicals in the wash process. The following list includes some, but not all, of the particularly corrosive chemicals that
if used in conjunction with Belanger® equipment will void the warranty: Hydrofluoric Acid, Ammonium Bi-fluoride,
Bromic Acid, Muriatic Acid, Sulfonic Acid, Phosphoric Acid, Hydrogen Cyanide, Hydrochloric Acid, and Chlorinated
Solvents. The Purchaser also agrees to accept the responsibility and liability for the selection and use of any chemicals
listed above;
However, should the end-user decide to use formulations containing any of the above ingredients, the end-user should
institute a comprehensive training program and implement detailed operational parameters within their organization for the
proper handling and treatment of such products to minimize the potential dangers involved. Consult your chemical supplier
for assistance in establishing operational guidelines in the use of their products. MSDS (Material Safety Data Sheet) should
be obtained from the chemical supplier before using any chemical formulation.
The installer is responsible for re-tightening ALL lugs, set screws, and terminals
located in the electrical panels during the installation process. Components may
vibrate loose during shipping.
CAUTION
