SpinLite® Full Side Washer
1MANUL961
Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681
59
Maintenance
Powder Coating Repair
Repair, fading, blemishes, and light scratches, to powder coating.
Repair faded powder coating
Faded powder coating means the surface of the coating has oxidized. This is usually only the
surface (2-3 microns). By rubbing with cutting compound, the oxidized surface will be removed and
new paint exposed with its original color. However, if the original coating was a matte finish it will
now have been polished to a gloss.
Repair light scratches and blemishes to powder coating.
Scratches may be deeper than 2-3 microns. Use cutting compound to remove the powder coating
down to the level at the bottom of the scratch. A fine rubbing down paper may speed up the process
(800 to 400 grit, no coarser), but the job will need to be finished with a cutting compound to remove
the fine scratches left by the rubbing down paper.
Repair Powder Aerosol
Cleaning prior to painting.
The original paint needs to be clean prior to ‘touch up or touching in’ repainting. Indoor components
may have been polished with polishes containing Silicone. Silicone will repel any further painting and
must be removed from the local area. Clean the surface by washing it with a detergent and a non-
scratch scrub sponge. Use a solution of warm water and non-abrasive, pH neutral (pH 5 -8)
detergent to clean material prior to painting. Thoroughly rinse and dry the surface. If solvents are
needed to remove marks, a soft cloth dampened with Isopropyl Alcohol may be used. Solvents
containing esters, ketones, or chlorinated solvents must not be used without consulting the paint
manufacturer, as these are too aggressive and will melt the paint. A small discrete area should be
tested first.
Repair Powder
The surface contaminants may need to be removed by abrading with fine rubbing down paper ‘400
grit’. If the component has been damaged, causing chipping or cutting to the paint, the loose flakes
should be
removed. ‘Ugly steps’ where the paint has been chipped need to be feathered. Coarse
rubbing down paper ’80 grit’ will do this faster, but it will leave noticeable scratches. Finer paper will
produce better results, 250 grit paper is a good compromise, (this will wear smooth quickly, so
replace it frequently).
Primer preparation
When the original paint edges have been rubbed down smooth and a step is not noticeable, remove
the dust, apply a light coat of paint/primer, and allow it to dry. This will show how well the area has
been prepared. Continue rubbing down and applying light coats, until the edges of the damaged
paint have disappeared. Applied properly, at this stage all physical signs of repair can be lost.
