SpinLite® Full Side Washer
1MANUL961
Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681
60
Maintenance
Powder Coating Repair
Application Technique for Aerosol
Apply three very light coats and allow each to dry. When the surface has been covered with the new
paint, heavier coats may be applied. Do not rush, as this will produce runs; allow two minutes
between each coat. The aerosol should never be nearer than 6 inches (150mm). Continue to move
when spraying and keep the same distance from the workpiece. Smooth strokes from side to side,
covering the local area of damage. Start to move the aerosol before releasing the paint, and before
the end of the stroke, stop releasing the paint. This should avoid ridges of paint at each end of the
stroke.
Patience
On a warm day, if each coat has been allowed to dry before the next application, it should be
possible to rub the paint down after about 30 minutes. If it starts to
‘drag and ball’ the paint, leave it
to dry further. It will now have to be rubbed right back to a smooth surface again, which may take
another hour. More patience is required. (The thinner the coats of paint, the faster they will dry.)
Types of Paint
The paint must have an aggressive solvent that will melt its way into the powder coating. An
indication of suitability is the amount of time it takes to dry. Household polyurethane, which takes 24
hours to harden, is not suitable. This will sit on the powder, instead of melting its way into it. The
result is that it will peel off. It is always a good practice to mechanically abrade a key by using
rubbing down paper or at least use a non-scratch scrub sponge. A small discrete area should be
tested first.
