SpinLite® Full Side Washer
1MANUL961
Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681
9
Specifications
Requirements
Physical
Tunnel space: required driver side
95-5/8
”
Tunnel space: required passenger side
95-5/8
”
Utility
Electrical
Two 1 HP, 3-Phase Motors, terminated in Junction Box at the top of the Leg. See the chart
below for requirements.
Two 24V Signal Wires from the configured LED SpinLite Lighting Panel, terminated at the
Junction Box at the top of each Leg Assembly
One 110V Control Wire terminated at Supplied Pneumatic Control Panel
Water
One 1/2” poly
-flow tube for Chemical/Water
, Tee’d to feed driver and passenger side
SpinLite®
Full Side Winder assemblies, terminated at Water Manifold on each Leg Assembly
Water Output: 6 GPM total (Two Nozzles per side: 1.5 GPM x 65°@ 40 psi per Nozzle)
Pneumatic
One
1/4”
poly-flow tube Main Pneumatic feed to Air Panel (1CFM)
Four
1/4” Airlines for Extend and Retract of the
Arm Cylinders on each SpinLite® Full Side
Washer® Assembly
Electrical
Voltage
Hz
FLA
Per Motor
208
60
4.6
230
60
4.2
480
60
2.1
575
60
1.7
DISCONNECT AND LOCKOUT ELECTRICAL POWER BEFORE SERVICING ANY
EQUIPMENT!
CAUTION
Always wear safety glasses when performing maintenance on any equipment.
CAUTION
It is recommended that a licensed electrician is contracted to perform all electrical installations.
CAUTION
A compressed Air System should be set correctly to support 90 PSI necessary to operate equipment,
but should never be set to deliver more than 120 PSI air pressure to the Belanger specified
equipment.
