SpinLite® Full Side Washer
1MANUL961
Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681
38
Installation
Install Hub Assemblies, LED Lights with Electrical Connections & ShineMitts
™
Load ShineMitts
™ on Hub Assemblies
2) The ShineMitts
™ must be loaded onto the driver and passenger side SpinLite® FSW Hubs with
the fingers of the ShineMitts
™ pointing in the opposite direction of one another. And, the head of
the Pin for the Clips must be pointing downward.
3) All of the ShineMitts
™ for the driver side SpinLite® FSW must be assembled as shown in the
image below on the left; there must be 40
pieces of the 19”, 32 pieces of the 22” and 16 pieces of
the 25” ShineMitts™ assembled this way.
4) And, all of the ShineMitts
™ for the passenger side SpinLite® FSW must be assembled as shown
in the image above on the right; there must be 40 pieces
of the 19”, 32 pieces of the 22” and 16
pieces of the 25” ShineMitts™ assembled this way.
5) Before installing the cleaning material onto the hub assemblies inspect all of
the ShineMitt™
assemblies and sort them into two groups, driver side, and passenger side assemblies.
6) If there is not the correct number of pieces of ShineMitts
™ for each assembly in each of the
different lengths then disassemble and reassemble as many as necessary to obtain the correct
number for both the driver and passenger side SpinLite® FSW.
Driver Side
ShineMitt™ Assembly
Passenger Side
ShineMitt™ Assembly
Step 3 & 5
The driver side ShineMitts™ are installed
onto the Hub in this orientation and the Pin
should have been assembled in this direction.
Step 4 & 5
The passenger side ShineMitts™ are installed
onto the Hub in this orientation and the Pin
should have been assembled in this direction.
Pin
Mitt
Fingers
Clips
Pin
Overhead View of Hub with
ShineMitt™ Cleaning Material
(7” diameter Hub)
Passenger Side
Driver Side
Fingers
Mitt
DIRECTION
of
TRAVEL
