SpinLite® Full Side Washer
1MANUL961
Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681
55
Installation
Utilities
Electrical Connections: Motor
Re-wiring Motors for a Different Voltage (Only if Necessary)
3) Run the main power line out to the SpinLite® FSW assemblies and make the wire connections
to the motor wires inside the Electrical Junction Boxes on the Leg Assemblies.
4) When everything is wired properly, close and seal the Junction Boxes be sure to not crimp
down on any of the wires.
5) Test to see if the SpinLite® FSW assemblies are functioning properly by using the Controller
to turn on each of the SpinLite® FSW assemblies.
6) Confirm that the wheels are rotating in the proper direction, see images below.
Rotation Direction:
•
Driver Side: Clockwise
•
Passenger Side: Counter Clockwise
CAUTION
It is recommended that licensed technicians are contracted to perform all utility installations.
All utilities MUST be installed in accordance with all local and national codes
Note:
Be sure to match the hub rotation shown below. If the rotation is opposite as shown below,
reverse two leads to the electric motors on the overload located in the Control Panel.
7) If the wheels are not rotating in the proper direction then reverse the two leads to the Motors
on the overload located in the Control Panel.
8) Reattach the Top Cover to Gearbox/Motor Assemblies.
Note:
The electrical connections are made with either heat shrink butt splices or dielectric grease
wire nuts.
Note:
Make sure electrical box penetrations are made with an approved method for wet conditions.
A proper cord grip should be used and installed correctly and a drip loop on incoming cables
is recommended to avoid any water intrusion.
Direction of
Travel
Driver Side
Passenger Side
