SpinLite® Full Side Washer
1MANUL961
Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681
78
Maintenance
Motor Gearbox and Torque Plate Replacement
Install Motor Gearbox & Torque Plate Assembly
26) Remove the Junction Box Cover on the Motor. Route the Motor Lead through the cord grip on
the Junction Box.
Make sure to tighten the Cord Grip fitting properly to prevent any water intrusion.
27) Reconnect the wiring leads to the previously tagged motor leads to maintain the proper wiring,
refer to the images below.
Note:
If there are insulated ring terminals on the Terminal Block, we recommend replacing them with
non-insulated ring terminals; which can be purchased at a local hardware store or 1ELECT-
FS855 can be purchased through our Aftermarket Sales Department.
Note:
The non-insulated ring terminals provide more room within the Junction Box to secure wiring
into position.
28) Reattach the Cover to the Junction Box on the Motor.
Note:
Be careful not to crimp or crush any of the existing wirings.
29) Once the Motor Gearbox unit is properly secured into position, power can be turned back ON.
Remove the cover from
the Junction Box.
Step 26a:
Route Motor Cable through Cord
Grip and into the Junction Box.
Step 26b:
Motor Wiring
Motor Wiring Diagram
inside the Junction
Box Cover
Reconnect the wires to the previously
tagged motor leads to maintain
proper wiring.
Step 27:
