97
Press Select until Gallons Used is highlighted, then press and
hold reset to zero the counter.
Feet
In the left window, distance is measured when the Master switch is turned
On. This measurement is reset every time the Master switch is
Sq. Yards
While spreading the
computer accumulates
the (Width X distance
sprayed) and keeps a
running total. Press
Select until Feet Spread
and Sq. Yards is
highlighted, then press
and hold Reset to zero the counter. Both Total Feet and Sq. Yards reset at
the same time.
Temp
At the bottom of the home page on the left and right after the Edit button
window disappears is the Set Temp and actual Temp. The Set Temp is the
high limit for the burner and will shut it off or prohibit it from turning on if
material temperature is hotter than the setting. The lower right is the
actual temperature of the product in the tank. Press any button and the
Edit button menu reappears, then repeatedly press Select until the Set
Temp window appears and press Edit. Use the Up and Down to change
the setting, then press OK.
Summary of Contents for BC-502/CRC
