Bearcat BC-502/CRC, Instruction Manual

Page: 101 / 164

101
(gallons/(length x width)). In order for the machine to spread
accurately it must be calibrated accurately.
1. On a smooth straight surface,
accurately tape measure a
distance of 1000 ft. Mark the
start and finish so they are visible
from the cab of the distributor.
2. Position the distributor on the
start line. Pick a reference point
on the tire or bumper that can be
lined up with the start line.
3. On the Home page of the display, select Feet spread/Sq. Yards and
press and hold Reset until it reads zero. Turn OFF all Spray Valve
Switches or turn the Valve Selector Dial Off.
4. Turn ON the Master Switch and drive the pre-measured distance.
Speed is not a factor so drive slow and strait. Upon approaching
the finish line slow down and turn Off the Master Switch when
your reference point lines up with the finish line.
At this point the Feet Spread should read 1000 ft. or the pre-measured
distance.
5. If the Feet Spread does not read the correct distance, press Next
until you reach the Settings Menu. Select Cal-1
6. Press Select until the F-Cal is highlighted. A pop-up window
should display Calibrate FPM and the footage measured.
7. Press Edit and use the Up and Down buttons to correct footage.
8. Press OK to save and exit.
G-Cal