39
Burner Operations
WARNING:
POTENTIAL FIRE OR EXPLOSION HAZARDS EXIST
WHEN OPERATING THE BURNERS. FAILURE TO
FOLLOW THE BURN OPERATION SAFETY PROCEDURES
COULD RESULT IN SEVERE BURNS, INJURY OR DEATH.
•
Locate and inspect the condition of your Fire Extinguisher
•
ALWAYS use the auto ignition switch or a hand torch
to ignite a burner. NEVER use a match or lighter.
•
ALWAYS make sure flues are covered by at least 6-inches
(152 mm) of material before heating.
•
Burners should NEVER be operated under the
following conditions:
1.
During unloading or loading operations.
2.
While the vehicle is unattended.
3.
While the vehicle is in motion.
4.
When the vehicle is parked in a confined area.
5.
When the content of the tank is unknown.
•
NEVER remove materials from the tank while the
burners are operating, or the automatic burner controls
are set to operate.
•
NEVER remove materials to the point of uncovering flues
from the tank within 20 minutes after heating.
Summary of Contents for BC-502/CRC
