Bearcat BC-502/CRC, Instruction Manual

Page: 73 / 164

73
i. If all is well, increase the pump speed to a maximum of
150 gallons per minute. The pump will pull asphalt from the
Supply Tank and push it to the Transfer tank.
j. When the desired amount of asphalt has been pumped, close
supply valve.
k. Loosen the hose connection at the supply valve so it will draw in
air to suck the hose clear. Do this for three minutes and then
remove the hose from the supply vessel, elevating it to help clean
it. If you wish, draw some diesel through the hose to help clean it.
l. Close Valve A.
m. On the Side Control
Panel, Push the Pump/
Valves (red button) to
stop Pump.
n. Switch the pump
direction to neutral.
o. Zero the Manual
Increase Speed dial.
p. Close the Transfer Valve.
q. On the Side Control Panel Select OFF Load Hose D.
r. Pull on the Pump/Valves (red button) to actuate C valve and
pump.
s. Select Reverse pump direction.
t. Turn Manual Increase Speed clockwise ¼ turn or about 40-60
GPM while observing the hose and the connections.
u. Loosen the hose connection at the Transfer valve so it will draw in
air to suck the hose clear. Do this for three minutes and then
remove the hose from the supply vessel, elevating it to help clean
it. If you wish, draw some diesel through the hose to help clean it.
v. Close Valve D.
w. On the Side Control Panel, Push the Pump/Valves (red button) to
stop Pump.
x. Switch the pump direction to neutral.
y. Zero the Manual Increase Speed dial.