Bearcat BC-502/CRC, Instruction Manual

Page: 70 / 164

BC-502/CRC
70
OFF Load Thru Valve D
WARNING: EXTREME CARE MUST BE USED DURING PUMPING
OPERATIONS TO MAKE SURE THAT SYSTEM COMPONENTS
OPERATE AT THEIR RATED PRESSURES. FAILURE TO
CHECK THE CONDITION OF ALL HOSES AND CONNECTIONS
WHEN PUMPING COULD RESULT IN SEVERE BURNS,
SERIOUS INJURY OR DEATH.
a. Connect transfer hose (inspect condition) from supply vessel to
Valve D.
b. On Side Control Panel,
Select OFF Load Hose D
and pull “Pump/ Valves”
(red button) to actuate
“C” valve.
c. Open Valve D.
d. Open Supply Valve.
e. With pump in
“Forward”, slowly turn
the Manual Increase dial clockwise to ¼ turn or approximately
(40-60 GPM). While observing all connections and the transfer
hose. If all is well speed pump up to desired transfer GPM,
(approximately 250gpm) when using a 3” transfer hose. Asphalt
will be pulled through Valve C and pushed through valve D to the
supply tank.
f. When the desired amount of asphalt has been pumped, switch
the Pump to Neutral.
g. Push the red Pump/Valves button.
h. Close the supply valve.
i. Pull the red Pump/Valves button.
j. Switch Pump to Reverse.