BC-502/CRC
76
•
ALWAYS
use the auto ignition switch or a hand torch to
ignite a burner. NEVER use a match or lighter,
•
ALWAYS
make sure flues are covered by at least 6-
inches (152 mm) of material before heating,
•
Burners should
NEVER
be operated under the
following conditions:
1.
Material level is below heat tubes.
2.
During pumping operations.
3.
While the vehicle is unattended.
4.
While the vehicle is in motion.
5.
When the vehicle is parked in a confined area.
•
NEVER
remove materials from the tank while the
burners are operating, or the automatic burner
controls are set to operate.
•
NEVER
remove materials from the tank within 20
minutes of heating. Hot heat tubes can ignite vapors
when exposed to oxygen.
Tank Circulation While Heating
Warm Asphalt
a.
On Cab Console select “Circulate Heat”.
b.
Select Pump “FOR” (forward).
c.
Select “Manual”.
d.
Use the GSY switch “INC” to set pump speed at 150 GPM.
e.
As you leave the cab, be sure the parking brake is set and the
asphalt tank gauge reads above the fire line.
f.
Open exhaust stack
g.
Start burners as needed.
h.
Do not allow the asphalt temperature to exceed the maximum
recommended by the supplier
Summary of Contents for BC-502/CRC
