Barudan BEXT 120V, Instruction Manual

Page: 213 / 284

11 - 6
Icon Parameter
Function/Action
Range Of
Value
Default
Value
11
Stitch Back
Controls the number of stitches the machine will
automatically back up after a thread break. If the
function is off, m/c will not back up after a thread
break. Otherwise, m/c backs up the number of
stitches entered in this parameter. E.g. set at 4,
the m/c automatically backs up four stitches after
a thread break.
*This function is ignored for Chenille/Lock stitch
machines.
0 – 7
[stitch]
4
12
Overlap
Designates the number of stitches to overlap when
automending. When embroidering towards the
point of reversal, the other heads start working a
few stitches before the point of reversal. *If
beginning of sewing after automending stitches
(with trimming) pulls the bobbin thread to the top
side, these extra stitches may cover the bobbin. *If
the head misses a few stitches after automending
stitches (with trimming), these extra stitches may
cover the blank spot.
*When MC#13 Auto Start value is 0, the m/c does
not stop after automending stitches. Therefore,
this function will not be activated.
*This function is ignored with Chenille/Lock
Stitch machines/Sequin Device running (code
“S1”)
0 – 7
[stitch]
4
13
Auto Start
If On, during automend, the m/c automatically
starts all heads without the operator using the
Start switch when it has sewn the total number
of stitches to automend.
0 = On, Automatically starts after Automend.
1 = Off
2 = Automatically starts after Automend and
Appliqué (Appliqué must be turned on in
program).
3 = Automatically starts after Appliqué only
(Appliqué must be turned on in Program).
*M/C always stops after automending if manual
trimming was done right before automending,
regardless of setting.
0 – 3 1