Barudan BEXT 120V, Instruction Manual

Page: 211 / 284

11 - 4
2. MC List
Icons Parameter
Function/Action
Range Of
Values
Default
Value
1
Borer 1
Switches off the thread break detector for the
needle fitted with a boring device. Enter the
number of the needle that has the borer. Set to 0
if a boring device is not in use.
0 – 15
[Needles]
0
2
Trim Jumps
Indicates the number of jump stitches that are
needed for the trimmer to automatically cut the
thread. If set at 3, when the machine reads three
or more consecutive jump stitches, it will stop
and trim the thread. If set at 0, the thread will
not be trimmed by any jump stitch.
0 – 9
[Stitches]
2
3
Lock Stitch
After starting up after a trim, the machine sews
lock stitches by the following methods:
1,11 = Split stitch – splits the first stitch into two
stitches.
* 2,12 = Small triangle–sews a small triangle.
* 3,13 = Back stitch = splits the first stitch into two
stitches then backs over the same two
stitches.
Settings 11 –13 should be used if stitches less than
0.5 mm need to be sewn at the start of sewing.
4 = Automatic lock stitches at start turned off.
After a trim, auto jumps to next stitch to sew.
14 = Automatic lock stitches at start turned off.
1 - 4
and
11-14
1
4
Clamp Type
1 = Double clamp action (recommended for thick
fabric: The clamp opens at 295 degrees,
(depending on Clamp Off Angle of MSU1) on
first stitch before the needle penetrates
garment and closes at 0 degrees.
2 = Single Clamp action (recommended for thin
fabric): The clamp opens on the second stitch
when sewing starts.
3 = Clamp and fork action (recommended when a
shorter tail is required at the start of sewing):
The clamp opens on first stitch before the
needle penetrates the garment.
1 - 5 1
5
Slow up Count
Controls the machine speed at the start of sewing to 180
RPM for the specified amount of stitches, then ramps up
to the normal sewing speed.
3 – 15
[Stitches]
3