Bard Sherlock 3CG, Instructions For Use Manual, Page: 17 / 464

15
Instructions For Use
English
4 Sherlock 3CG™ TCS Catheter Guidance
4.1 Verifying Catheter Compatibility
The Sherlock 3CG™ TCS on Site~Rite® 8 Ultrasound System is compatible with the following PICCs as described below:
- The PICCS indicated with [ ] are compatible for ECG and Magnet Navigation [ ].
- The PICCs indicated with [ ] are only compatible for Magnet Navigation [ ].
4.2 Catheter Placement
Step 1: Prepare Device
- Connect the sensor to the Site~Rite® 8 Ultrasound System via USB cable.
- Verify that the ECG flatline signal is scrolling.
- Verify the battery charge is sufficient for the procedure.
- Enter Patient Information as needed.
Step 2: Position Patient and Perform Ultrasound Pre-scan
- Refer to the Bard Access Systems’ Site~Rite® 8 Ultrasound System Instructions for Use.
Step 3: Measure Catheter Length
- Refer to Bard Access Systems’ Catheter Instructions for Use.
Step 4: Prepare Sensor
- Slide the Fin Assembly on to the sensor until fully seated.
- Place sensor in the sensor holder with the fin and ECG electrodes remaining outside the holder and tighten the cinch ring.
[1] [2]
[3] [4]