Barco XHD-200, User Manual

Page: 109 / 287

Genlock
This section of the Properties pane displays the support for generator locking a Player.
Figure 5.42. Player Genlock
The following properties can be configured:
Enable Genlock: Toggles genlock between enabled and disabled.
Signal Source: Specifies the genlock source.
The source for the server can be either a coax signal or one of
the displays. The source for other players can be either a coax
signal or a the signal from the server transmitted in RJ45 port
#1. (See
Connections (p.60) .)
Status: Displays the status of the genlock.
Refresh: Refreshes the status of the genlock, or tries to reapply genlock
if it is not currently working.
Display Enabled: Enables genlock for a specific display.
Display Status: Displays the status of the genlock for a specific display.
Topologies
X-Agora uses two possible topologies for the genlock:
• All players and the server are synced by means of a coax signal in all
the machines. The signal source on all players and the server should be
"Coax."
• All players are synced to the server's signal. The server's signal source
can be either coax or one of its displays. Set the signal source on all
players other than the server as
RJ45-1 . To send the signal from one
machine to another, connect the RJ45 port #2 from one machine to the
RJ45 port #1 on the next machine until all machines are chained.
Barco Pn: 60600320 106
Section 5: Workflow layouts Barco Media Server XHD-Series User Guide