Bandai Namco DARK ESCAPE 4D, Operation Manual

Page: 126 / 209

124
8B. Service
- Must be performed by a technician -
Remove the hexagon nut, spring washer and flat washer, and remove the variable registor (for right/
left) from the variable registor bracket (1).
Replace the variable registor.
Hexagon nut
(Do not over-tighten)
Variable registor bracket (1)
Variable registor
(for Right/Left)
Flat washer
Spring washer
Protrusion

The variable registor (for right/left) appears the same as the variable registor (for up/down). Check
the harness colors before replacing the variable registor.

When installing, lock the connectors securely.

When installing the variable registor, align the flat surface of the variable registor shaft with the
set screw position.
Flat surface of variable
registor shaft
Set screw
To install, perform the procedure in reverse.

When installing, install each part in the relative position shown in the figure below.
Variable registor gear
Black dot
Variable registor bracket (1)

When installing, be careful not to pinch the harness in the gears.

After replacement, be sure to initialize the variable registor.
(See “7-7-4(c) Crosshairs and Gun Vibration Unit Check Screen (GUN TEST)” on page 48.)