Bandai Namco DARK ESCAPE 4D, Operation Manual

Page: 158 / 209

156
8B. Service
- Must be performed by a technician -
(8) Replacing the 3D Glasses
3D glasses are attached to both the L and R sides of the rear assembly. The description below explains how
to replace the 3D glasses on the L side. Perform the same procedure to replace the 3D glasses on the R side.

Replace the 3D glasses when they become damaged or excessively dirty.
Use the supplied Allen wrench to loosen the hexagon socket set screw (M2.6 x 5), remove the curly
wire clip, and remove the 3D glasses from the curly wire cord.
Insert the curly wire cord into the hole in the temple of the new 3D glasses from the bottom.
Attach the curly wire clip so that the edge is aligned flat with the tip of the curly wire cord, and tighten the
hexagon socket set screw (M2.6 x 5) with the supplied Allen wrench to secure the curly wire clip.
Adjust the curly wire clip on the other side so that there are no gaps between the curly wire clips and
the temple of the 3D glasses.
Align the edges.
Allen wrench
Allen wrench
Hexagon socket
set screw
(M2.6 x 5)
Hexagon socket set
screw
(M2.6 x 5)
Hexagon socket
set screw
(M2.6 x 5)
Curly wire clip
Adjust the position
so that there are
no gaps.
Curly wire cord
3D glasses
(Replace with spare)
Perform the same procedure to replace the 3D glasses on the R side.

The curly wire cord is attached to different sides of the 3D glasses for the R and L sides. Be careful
to attach the curly wire cord to the correct side.