AudioCodes Mediant 4000 SBC, User Manual

Page: 907 / 1037

CHAPTER 60 Configuration Parameters Reference
Mediant 4000 SBC | User's Manual
Parameter Description
'Trap Community String'
configure system > snmp trap >
community-string
[SNMPTrapCommunityStringPassword]
Defines the community string for SNMP
traps. For more information, see
Configuring
SNMP Community Strings on page 62.
Serial Parameters
The serial interface parameters are described in the table below.
Table 60-6: Serial Parameters
Parameter Description
[DisableRS232] Enables the device's RS-232 (serial) port.
■ [0] = Enabled
■ [1] = (Default) Disabled
The RS-232 serial port can be used to change the networking
parameters and view error/notification messages. To establish serial
communication with the device, see
Establishing a CLI Session .
Note: For the parameter to take effect, a device reset is required.
[SerialBaudRate] Defines the serial communication baud rate.
The valid values include the following: 1200, 2400, 9600, 14400, 19200,
38400, 57600, or 115200 (default).
Note: For the parameter to take effect, a device reset is required.
[SerialData] Defines the serial communication data bit.
■ [7] = 7-bit
■ [8] = (Default) 8-bit
Note: For the parameter to take effect, a device reset is required.
[SerialParity] Defines the serial communication polarity.
■ [0] = (Default) None
■ [1] = Odd
■ [2] = Even
Note: For the parameter to take effect, a device reset is required.
[SerialStop] Defines the serial communication stop bit.
■ [1] = (Default) 1-bit (default)
■ [2] = 2-bit
Note: For the parameter to take effect, a device reset is required.
[SerialFlowControl] Defines the serial communication flow control.
■ [0] = (Default) None
■ [1] = Hardware
Note: For the parameter to take effect, a device reset is required.
- 874 -