CHAPTER 18 Core Entities
Mediant 4000 SBC | User's Manual
Parameter
Description
'Proxy Address'
proxy-address
[ProxyIp_IpAddress]
Defines the address of the proxy server (Proxy Set). The address
can be defined as an IP address in dotted-decimal notation (e.g.,
201.10.8.1) or FQDN. You can also specify the port using the
following format:
■
IPv4 address: <IP address>:<port> (e.g., 201.10.8.1:5060)
■
IPv6 address: <[IPV6 address]>:<port> (e.g.,
[2000::1:200:200:86:14]:5060)
Note:
■
When configured with an FQDN, you can configure the periodic
rate at which the device performs DNS queries to resolve the
FQDN into IP addresses. For more information, see the
ProxyIPListRefreshTime parameter.
■
When configured with an FQDN, you can configure the method
(e.g., A-record) for resolving the domain name into an IP
address, using the 'DNS Resolve Method' parameter in this
table (see above).
■
You can configure the device to use the port indicated in the
Request-URI of the incoming message, instead of the port
configured for the parameter. To enable this, use the IPGroup_
SBCRouteUsingRequestURIPort parameter for the IP Group
that is associated with the Proxy Set (
).
■
If you are configuring the Proxy Sets with IP addresses, it is
highly recommended to configure each Proxy Set with a unique
IP address. Configuring multiple Proxy Sets with the same IP
address can cause problems classifying incoming SIP requests
to source IP Groups based on Proxy Set. If you have configured
multiple Proxy Sets with the same IP address, the device uses
the Proxy Set with lowest Index number. For example, if you
have configured Proxy Set ID #1 and Proxy Set ID #4 with the
same IP address, the device uses Proxy Set ID #1 to classify
the incoming SIP request to an IP Group.
However, configuring multiple Proxy Sets with the same IP
address, but with different SIP Interfaces is acceptable for clas-
sifying incoming SIP requests to source IP Groups based on
Proxy Set.
For more information on determining the Proxy Set, see the
'Classification Input' parameter (above) parameter .
'Transport Type'
transport-type
[ProxyIp_
TransportType]
Defines the transport type for communicating with the proxy.
■
[0]
UDP
■
[1]
TCP
■
[2]
TLS
■
[-1] = (Default) Not configured. The transport type is according
to the settings of the global parameter, SIPTransportType.
'Proxy Priority'
priority
[ProxyIp_Priority]
Defines the priority of the proxy. When a proxy server goes offline,
the device attempts to connect to an online proxy server that has
the highest priority.
The valid value is 0 to 65535, where 0 is the highest priority and
65535 the lowest. The default is 0.
- 377 -
Summary of Contents for Mediant 4000 SBC
