AudioCodes Mediant 4000 SBC, User Manual

Page: 591 / 1037

CHAPTER 25 Routing SBC
Mediant 4000 SBC | User's Manual
Parameter Description
'IP Group Set'
ipgroupset-name
[IP2IPRouting_
IPGroupSetName]
Assigns an IP Group Set to the routing rule. The device routes the
call to one of the IP Groups in the IP Group Set according to the
load-balancing policy configured for the IP Group Set. For more
information, see
Configuring IP Group Sets .
Note: The parameter is applicable only if you configure the
'Destination Type' parameter to IP Group Set (above).
'Call Setup Rules Set
ID'
call-setup-
rules-set-id
[IP2IPRouting_
CallSetupRulesSetId]
Assigns a Call Setup Rule Set ID to the routing rule. The device
performs the Call Setup rules of this Set ID if the incoming call
matches the characteristics of this routing rule. The device routes
the call to the destination according to the routing rule's configured
action, only after it has performed the Call Setup rules.
To configure Call Setup rules, see Configuring Call Setup Rules .
'Group Policy'
group-policy
[IP2IPRouting_
GroupPolicy]
Defines whether the routing rule includes call forking.
■ [0] None = (Default) Call uses only this route (even if Forking
Group members are configured in the rows below it).
■ [1] Forking = Call uses this route and the routes of Forking
Group members, if configured (in the rows below it).
Note: Each Forking Group can contain up to 20 members. In other
words, up to 20 routing rules can be configured for the same Forking
Group.
'Cost Group'
cost-group
[IP2IPRouting_
CostGroup]
Assigns a Cost Group to the routing rule for determining the cost of
the call.
By default, no value is defined.
To configure Cost Groups, see Configuring Cost Groups .
Note:
■ To implement LCR and its Cost Groups, you must enable LCR
for the Routing Policy assigned to the routing rule (see
Configuring SBC Routing Policy Rules ). If LCR is disabled, the
device ignores the parameter.
■ The Routing Policy also determines whether matched routing
rules that are
not assigned Cost Groups are considered as a
higher or lower cost route compared to matching routing rules
that are assigned Cost Groups. For example, if the 'Default Call
Cost' parameter in the Routing Policy is configured to
Lowest
Cost , even if the device locates matching routing rules that are
assigned Cost Groups, the first-matched routing rule without an
assigned Cost Group is considered as the lowest cost route and
thus, chosen as the preferred route.
'Routing Tag Name'
routing-tag-name
[IP2IPRouting_
RoutingTagName]
Defines the destination Dial Plan tag, which is used to determine the
destination IP Group.
The valid value is a string of up to 70 characters. Only one tag can
be configured. Only the tag name must be configured (not the value,
if exists). For example, if the tag is configured in the Dial Plan rule
as "Country=England", configure the parameter to "Country" only.
The tag is case insensitive.
- 558 -