AudioCodes Mediant 4000 SBC, User Manual

Page: 368 / 1037

CHAPTER 18 Core Entities
Mediant 4000 SBC | User's Manual
■ IP-to-IP Routing rules for specifying the destination SIP Interface to where you want to route
the call. For more information, see
Configuring SBC IP-to-IP Routing Rules .
■ Classification rules for specifying the SIP Interface as a matching characteristic of the
incoming call. This is especially useful for the single SRD-configuration topology, where each
SIP Interface represents a Layer-3 network (SIP entity). Therefore, classification of calls to IP
Groups (SIP entities) can be based on SIP Interface.
The SIP Interface can also be used for tag-based classification of incoming SIP dialogs if the
SIP Interface is configured with a Call Setup Rule Set ID that determines the source tag. For
more information, see
Configuring Classification Based on Tags on page 544.
For more information on classification, see Configuring Classification Rules .
■ Tel-to-IP Routing rules for specifying the destination SIP Interface to where you want to route
Tel-to-IP calls. For more information, see Configuring Tel-to-IP Routing Rules.
■ IP-to-Trunk Group Routing rules for specifying the SIP Interface as a matching characteristics
for the incoming IP call.
The device terminates active calls associated with a SIP Interface if you do one of the
following:
● Delete the associated SIP Interface.
● Edit any of the following fields of the associated SIP Interface: 'Application Type',
'UDP Port, 'TCP Port', 'TLS Port' or 'SRD' fields.
● Edit or delete a network interface in the IP Interfaces table that is associated with
the SIP Interface.
The following procedure describes how to configure SIP interfaces through the Web interface. You
can also configure it through ini file [SIPInterface] or CLI (
configure voip > sip-
interface
).
➢
To configure a SIP Interface:
1. Open the SIP Interfaces table ( Setup menu > Signaling & Media tab > Core Entities folder
> SIP Interfaces ).
2. Click New ; the following dialog box appears:
3. Configure a SIP Interface according to the parameters described in the table below.
4. Click Apply .
- 335 -